The Panel-Beating Machine – The ZR Design
The ZR model is a newly constructed, sturdy and fully hydraulic swing-folding machine with standard lengths of 3.2 m (10.5 ft) up to 12.0 m (39.37 ft); it was developed especially for the sheet metal workshops. This model can be adapted to requirements with a variety of accessories.
The machine is manufactured in a clean welded structure and painted with a two-part hammered finish silver. The flanges are painted in a bright yellow, coated with a two-component lacquer. All drive shaft bearings are made from top-quality bronze. All other bearings subject to wear are tempered and ground. On the ZR – Model, the clamp beam and the bending flange are driven over separate camshafts in order to achieve exact parallel courses of motion.
Standard equipment
- Complete electrical and oil-hydraulic installation
- Safety equipment
- Integral leveling device
- Quick adjustment of clamp beam radius and angle position on each pedestal
- DS 3001 control panel
- Programmable back gauge
- Hydraulic system filled with required oil quantity
- Foot pedal operation of clamp beam and bending flange
- All-phase main switch
- Freely selectable clamping beam geometry curved (standard) or straight
- The machine needs only little maintenance work
Special accessories / special equipment
- Hydraulically-operated automatic cutter
- Adjustable cutting head with sheet support roller
- Bending flange width 10 mm (0.4”) + 10 mm (0.4”) additional track
- Laser monitoring of the clamping range
- Variable back gauge for short profiles
